Q:<\/strong>I am almost done with electric bike kit, everything is okay except the throttle is not working. I connected the old throttle from my old e-bike, it\u2019s connections fits the lcc-001 controller.But as I connect it, the motor doesn\u2019t run at all. Answer 1:<\/strong>Please check three-pin throttle connector.<\/p>\n Answer 2:<\/strong>Disconnect and re-connect these two connectors.Check male-female connector and pins. Answer 3:<\/strong>Make your electric bike kit wheel in the air,short red and green wires(3-pin throttle connector on controller). Answer 4:<\/strong>Yeah,jump red and green wires.If your system is no problem,e-bike can run at once. Answer 5:<\/strong>You had better to cut off three-pin throttle connector.Then connect wires as below: If you have volt-meter,pls power on,then test voltage from controller throttle connector.
\nWhat kind of throttle is to be connected to this controller to achieve speed control from 0 to full speed: meter type or Hall Effect type?
\nMy current throttle is 3 wired connected to a very small chip, which is moving along a magnet.<\/p>\n
\nIf still not work,buy a new throttle or use a meter to replace.<\/p>\n
\nPower on battery,motor will run as the fastest speed at once.
\nIf not,it’s not throttle issue.<\/p>\n
\nMake sure your electric bike kit<\/code> wheel in the air.<\/p>\n
\nThrottle —– Controller
\nred —– red
\nblack —– black
\nwhite —– green<\/p>\n
\n1.red and black is about 4.5V
\n2.green and black is about 2.3V<\/p>\n