Leafmotor

electric bike kit doesn’t work…
Q:Help me! my electric bike kit doesn’t work. Then I turn on the key on the battery the 3 lights on the thumb throttle starts to light. then I press the thumb throttle the motor make a small noise 1 second and doesn’t work. The 3 lights doesn’t light anymore until about 30 seconds later.
I haven’t installed the PAS. Do I have to do that before the bike will be able to spin?
A:Don’t worry.
Could you take a photo with your wires how to connect about your electric bike kit?
1.Non’t connect eight wires(5 hall+3 motor) of motor,turn the motor with your hand.If it runs freely means the motor is good.
2.Then try electric bike kit again
1).disconnect the cruise green connector(green and blue wires)
2).check the throttle connector,make three wires are connected well.(red -red,black-black,green-white) or you could use another twist throttle to replace this.
3).make sure the connector of the battery positive is good.
Q:I disconnect the wires to the motor and the wheel run freely. I connect again.

I disconnect cruise control (green and blue)
I check throttle wires, okay
I check battery wires
I turn on the battery with the key and press the throttle but there is no difference. (It doesn’t work)
I remove the thumb throttle and replace it with the twist throttle , but it still doesn’t work.
I connect the cruise control but its still doesn’t work.
A:Is your thin red battery wire(power switch) connected okay,this wire means a lock,if you connect this wire to battery +,it will make the motor run.
If this isn’t connected well,electric bike kit can’t work.
Q:I took a look at the thin red wire (power switch) that is connected to the bigger red wire labeled +. It look good and has no loose ends.