Q: I bought the 26 inch rear 1000 watt electric bike kit how do you wire the headlights to it I see a headlight display on the LCD screen and a switch for the headlights but no wiring diagram for that.
A: How to use three button switch?
1.We cut off that blue wire.It’s for reverse. If reconnect this blue wire. (Reverse is dangerous for e-bike. So we cut off blue wire)
This yellow button be left / middle,hub motor works forward. Be right side,motor works bacwkard / reverse…
2.Green button is used to control cruise, while hub motor is running,also over some speed,example: over 1/3 max speed,at this time,press green button one time,then loose throttle,LCD display “C”,motor will works the same speed. Re-press this green button one time or press brake lever or turn throttle to max,motor will stop
3.Red button be up,regen on. Be down,regen off. This regen is not strong.Only while braking with a little regeon.
Q: I appreciate your help in this matter is there anyway I can get a copy of the proper settings for the P and C settings on the LCD for the 48 volt rear hub motor kit.
I understand that but when I was trying to set. I’m afraid I opened the P settings and then went into the P settings before I realize what was going on I’m scared I might have changed something is there any way to get a copy of the P and C settings or will a factory reset work if there is any possible way to get a copy of what the p and c settings are supposed to be so I can double-check them it would be greatly appreciated.
A: P1 = 46
P2 = 0
P3 = 1
P4 = 0
P5 = 15
Q: My battery management chip on my battery was not plugged in all the way so I think that may have been the problem I’m charging it all the way up now I appreciate it though thank you very much just out of curiosity is there anyway you can get me the C settings for that 1000W rear hub motor kit .
Comments are closed.