Leafmotor

Q: Received my 26 inch rear electric bike kit. Finally managed to get it all working. The LCD display does not go over 20 mph ? Can you think why？

A: Do you make you hub motor “reverse”?

* If you make the three button switch to be “R”, bike motor will be reverse, the speed is slow. Make to “L”, bike motor will be forward.

Q:I have disconnected the three button switch and now seems to be working. The display when the ebike is in use does not go above 20 mph. does the display after you have set the mph/kmh mean ? It says p1, p2,p3,p4 and p5. What are the correct settings for these ?

A:Your electric bike kit can reach 40 mph without load, we test it. Even if you ride, still can reach about 35mph.
Please set the wheel size to be “26” It’s wheel size.
* Power on, turn on LCD, then press “up” and “down” button for 2 second together.
1. Then max speed will flashing. Make it to be max 72kmh.
2. Then “kmh or mph” will flashing. Press “up” or “down” to shift from “kmh” to “mph”. Then press “ON /in the middle of button” to done setting.
3. Then “wheel size,8,10,12,14,16,18,22,24,26,700 or 28” will flashing. Press “up” or “down” to shift. Make it to be “26” Then press “ON /in the middle of button” to done setting.

* After setting these 1,2,3. Then press “ON /in the middle of button” for 2 second. It will save these setting.
* After setting these 1,2,3.Then press “UP” and “Down” switches. Then start to set P1,P2,P3..

Don’t set P1,P2,P3,P4,P5
If make a mistake.

Please set it as below:

P1:46 (This hub motor has 46 pcs magnet,can’t set to other,it’s used to display correct speed)
P2:0 (That is low speed motor — without gears inside motor)
P3:1 (With pedal assist)
P4:0 (Start from 0 speed)
P5:15 (24V be 9; 36V be 12; 48V be 15)

Q: Great. After setting this P1, the hub motor works well. Correct, 40mph. Nice electric bike kit.